Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: softselect on January 07, 2010, 03:33:34 PM
-
Hi everyone,
I have just revamped my "all in one" lathe screen and i found the feedrate override% values change in the DRO but during a cut it does not affect the feed rate
anyone else have the same problem?
my new all in one screen set can be found here
http://www.machsupport.com/forum/index.php/topic,13544.msg88912.html#msg88912
thanks
Friedrich
-
I think it works fine for me but I am not using the latest version of Mach, I will try and remember to make sure tomorrow.
Hood
-
Just tested here and FRO works fine with both G95 and G94 but I am using an older version on the lathe (021) and also the SmoothStepper. Maybe RC or Rich will be able to test for you with the parallel Port.
Hood
-
Thanks Hood at least i know the screenset is ok
-
ah, didnt try with your screenset, sorry, will try later if I get a chance, kind of busy with the lathe at the moment
-
ok tried your screenset and its working :)
Hood