Hello Guest it is September 25, 2022, 12:52:34 PM

Author Topic: Cool New Feature  (Read 2896 times)

0 Members and 1 Guest are viewing this topic.

Cool New Feature
« on: December 27, 2009, 08:04:03 AM »
Hi Klaus,

In the top right hand corner is the box displaying the properties.

Would it be possible to add the two figures together so that a dro displays LEFT EDGE + WIDTH & TOP EDGE + HEIGHT

This would then make a total of 6 dro's

Reasoning i position my box at the required top and left edges but i want the box to finish at the screen edge

Maybe it could be that you could fill in the right edge and this would calculate the width etc

Thanks
Phil
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable
Re: Cool New Feature
« Reply #1 on: December 28, 2009, 05:31:58 AM »
Hi Phil,

I implemented your suggestion in version V1.35 which can be downloaded from my site. When you change left, right, top or bottom parameter, the width / height is calculated. If width or height is < 2, the entry is ignored and an error is thrown.




Klaus
The brain isn't a soap, it doesn't shrink when used.
Re: Cool New Feature
« Reply #2 on: December 28, 2009, 07:07:35 AM »
Hi Klaus,

You are truly amazing amazing.

Phil
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable