Machsupport Forum
Mach Discussion => Mach Screens => Machscreen Screen Designer => Topic started by: M250cnc on December 27, 2009, 08:04:03 AM
-
Hi Klaus,
In the top right hand corner is the box displaying the properties.
Would it be possible to add the two figures together so that a dro displays LEFT EDGE + WIDTH & TOP EDGE + HEIGHT
This would then make a total of 6 dro's
Reasoning i position my box at the required top and left edges but i want the box to finish at the screen edge
Maybe it could be that you could fill in the right edge and this would calculate the width etc
Thanks
Phil
-
Hi Phil,
I implemented your suggestion in version V1.35 which can be downloaded from my site. When you change left, right, top or bottom parameter, the width / height is calculated. If width or height is < 2, the entry is ignored and an error is thrown.
Klaus
-
Hi Klaus,
You are truly amazing amazing.
Phil