guys,

i need help finding out whats going on with my program...I designed the part in bobcadcam V21.  I then uesd the mach1 postprocessor from the mach site to write the program.  After i start the program it goes to line 2861 and says something about the radius differing.  the txt code is attached

Hi, Krymis

In General Config, Check your IJ settings, Loads fine hear.

Chip

chip,

thanks that worked.  What does that IJ mode in absolute or inc. have to do with making it work? Also how can I easily add in an Optional stop at every z move to manually lower my z axis until the new z axis is plates are done?