Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: krymis on November 09, 2009, 01:10:17 PM

Title: nedd program help
Post by: krymis on November 09, 2009, 01:10:17 PM

guys,

i need help finding out whats going on with my program...I designed the part in bobcadcam V21.  I then uesd the mach1 postprocessor from the mach site to write the program.  After i start the program it goes to line 2861 and says something about the radius differing.  the txt code is attached

Title: Re: nedd program help
Post by: Chip on November 09, 2009, 01:21:38 PM

Hi, Krymis

In General Config, Check your IJ settings, Loads fine hear.

Chip

Title: Re: nedd program help
Post by: krymis on November 09, 2009, 01:54:27 PM

chip,

thanks that worked.  What does that IJ mode in absolute or inc. have to do with making it work? Also how can I easily add in an Optional stop at every z move to manually lower my z axis until the new z axis is plates are done?