Hello Guest it is March 28, 2024, 07:53:29 PM

Author Topic: THC300 arc voltage  (Read 3396 times)

0 Members and 1 Guest are viewing this topic.

THC300 arc voltage
« on: August 24, 2006, 04:12:12 PM »
What is the voltage range to adjust the arc distance while cutting.
Best regards, Kees
Re: THC300 arc voltage
« Reply #1 on: August 25, 2006, 11:35:36 AM »
You may have to mail Jim C for that one :(
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: THC300 arc voltage
« Reply #2 on: September 25, 2006, 02:46:27 PM »
It will adjust from about 200v down to 50 v on the older units.
I have added a switch and resistor make it adjust lower for fine consumables.
If you what the mod email me off list and I will send it to you.
JimC