Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Kees Holland on August 24, 2006, 04:12:12 PM

Title: THC300 arc voltage
Post by: Kees Holland on August 24, 2006, 04:12:12 PM

What is the voltage range to adjust the arc distance while cutting.

Title: Re: THC300 arc voltage
Post by: Brian Barker on August 25, 2006, 11:35:36 AM

You may have to mail Jim C for that one :(

Title: Re: THC300 arc voltage
Post by: jcullins on September 25, 2006, 02:46:27 PM

It will adjust from about 200v down to 50 v on the older units.
I have added a switch and resistor make it adjust lower for fine consumables.
If you what the mod email me off list and I will send it to you.
JimC