Hello Guest it is September 20, 2019, 04:26:34 AM

Author Topic: Interface bwteen the parallel ports and Servo motors  (Read 5497 times)

0 Members and 1 Guest are viewing this topic.

Interface bwteen the parallel ports and Servo motors
« on: August 17, 2006, 03:43:34 PM »
Friends:
I need a breakout board to interface the parallel port and Yaskawa servo motors (Amplifiers).

I am working on a project of 5 axis CNC router.
Is any commercial breakout board available?

Thanks
Re: Interface bwteen the parallel ports and Servo motors
« Reply #1 on: August 17, 2006, 08:10:40 PM »
I think Bob C has a board that will plug into the 2nd p port..
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Interface bwteen the parallel ports and Servo motors
« Reply #2 on: August 18, 2006, 01:52:12 PM »
I am unable to contact with  Bob C. He is alway on vacation?
do you know his phone number?
Thanks
Re: Interface bwteen the parallel ports and Servo motors
« Reply #3 on: August 18, 2006, 08:59:36 PM »
I don't know his number :( But any of the breakout boards ahould work.. you just need to have two of them :) you can set up a second port in Mach and it will use the same hardware :o

PMXD has a nice setup as well as cnc4pc

Hope that helps
Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Interface bwteen the parallel ports and Servo motors
« Reply #4 on: August 23, 2006, 04:31:17 PM »
Thanks:
I will order the CNC4PC board.