Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ericma on August 17, 2006, 03:43:34 PM
-
Friends:
I need a breakout board to interface the parallel port and Yaskawa servo motors (Amplifiers).
I am working on a project of 5 axis CNC router.
Is any commercial breakout board available?
Thanks
-
I think Bob C has a board that will plug into the 2nd p port..
-
I am unable to contact with Bob C. He is alway on vacation?
do you know his phone number?
Thanks
-
I don't know his number :( But any of the breakout boards ahould work.. you just need to have two of them :) you can set up a second port in Mach and it will use the same hardware :o
PMXD has a nice setup as well as cnc4pc
Hope that helps
Brian
-
Thanks:
I will order the CNC4PC board.