Hello,
I have a problem with the output 2 . I have a the output# 1 enabled , port# set to 1 and pin Number set to 1 too, the spindle work well.
But the output# 2 enabled , port# set to 1 and pin Number set to 14 ,nothing works..all is wired as in the output # 1, nothing changes but it does not work..
I use breakout board campbell.. and I use the same relay , but only one that works...
Did I do something wrong? I have tried to do the same with output#3, but I had the same result...
Could I have your help?
thanks in advance
Robhi