Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Robhi on February 14, 2009, 11:24:12 AM

Title: Problem with outputs
Post by: Robhi on February 14, 2009, 11:24:12 AM
Hello,

I have a problem with the output 2 . I have a the output# 1 enabled , port# set to 1 and pin Number set to 1 too, the spindle work well.

But the output# 2 enabled , port# set to 1 and pin Number set to 14 ,nothing works..all is wired as in the output # 1, nothing changes but it does not work..
I use breakout board campbell.. and I use the same relay , but only one that works...

Did I  do something wrong? I have tried to do the same with output#3, but I had the same result...


Could I have your help?
thanks in advance
Robhi
Title: Re: Problem with outputs
Post by: Chip on February 14, 2009, 12:56:25 PM
Hi, Robhi

What are you trying to turn on, Have you used the appropriate M-code to turn it on & off ?.

Have you tried changing the Active Low state in ports & pins ?.

Chip
Title: Re: Problem with outputs
Post by: Robhi on February 14, 2009, 04:10:43 PM
Hi everybody , hi Chip :) :)

Promlem is solved..

thanks for your replay, I try to turn a vaccum on and off. I did use the appropriate M.code.
Problem is solved.. the problem was that I reversed the wires of in the input I just reversed them and everything is OK.

thanks Chip and for all you. :)
Robhi