OK, This is very interesting so far.
Now I have selected T1, and in my tool selections put in the dia. of .1875 for my end mill.
See the prog below,
Under "Config" then "Toolpath Config" I have these checked so I can view the actual cam being cut.
Show Lathe Object X
A Rotations Enabled X
Axis of Rotations = Z-Axis
Now when the endmill moves to the first cut @ x.965 the Y does offset to +.094
This is good so far, then as the EM moves up the rise, it gets too close to the corner and then
goes beyond the dia. like it should to allow for the EM dia.
Then it runs over the x1.910 rad and beyond like it should. Then down the return good. then it follows
the x .965 rad back home but goes too far into the first rise. ??
I notice it does not allow for x comp on the x .965 at all but does on the x 1.910 rad.
So its comping the Y ok except the first rise top and only comping the x at the top.
I did up a cam with two diff rise segments and the comp was confusing because of needing G41 then G42 then ....you see what I mean?
SO if you get time, try this out and see if it does the same on yours and what your thoughts are about it.
( 111111 )
( CC2 Cam )
( D4 )
G90
G0 Z0
G1 A10.0 Y0 F200
G42
G1 A0 X 0.965 F100 ( .945 )
G1 Z-2.5 F200
G1 Z-2.650 F5
M01
Z-2.800 F5
G91
F200
N 4 A 35 X 0.945 Y.094
N 6 A 50 F200
G41
N 7 A 20 X -0.9449
G40
N 9 A 255
G90
G0 Z0
G1A380X2.5Y0F200
G0 A360
G92 A0
M30
Thank you