Looks to be working well
Think I would be spinning slower and feeding harder though.
Hood
Yaa.. The system is working well now... Following is my experience:
1- The HSS drill failed on the Second hole... I kept the RPM 800 and G73 cycle with Peck 6mm.. It simply toasted;) Flood coolant was On... 2min/hole
2- The second bit is used was Carbide, It ran for 30 holes and then suddenly break into 3 pieces... Again G73 peck cycle but with 2.5mm peck... 2 minute/hole
3- I then used HSCO drill and with G83 Cycle, lost it after 38th hole with 2.5mm peck... Coolant on.. 7minute /hole
4- Keeping all above experience in view, i again used HSCO drill but at this time G83 with 2mm peck (DOC) and after each 15 holes i sharpen the drill.. For this i added tool change command after each 15 holes in my Gcode.. i slightly changed the Gcode for downtime...
The above strategy went very good and i did above 100holes without breakage... 5minute /hole
5- I have HSS drills available, so i tried the same G83 cycle with them with 2mm peck and sharpening after each 15 holes..and i did 50 holes without loosing HSS drill.. 4.5min /hole
I have done 224 holes in 16.8 hours.