Hi, I have the router running nc files and homing all ok. I have one problem, I have noticed that a power point or light swiitch when turned of or on is sending a pulse to the cnc and throwing the safety /stop button. All micro homing switch leads are earthed. any ideas to stop this please.
Also I have set up a tool depth set micro , it sits about 200mm in from the end and side of the table and is clear of the machining area. How do I tell mach 3 where this micro switch mechanism is, set the tool depth (surface of the work piece) and then get the XYZ axis to return to the zero point to start work. I am using Enroute pro for all my toolpathing which sets my tool at top of surface.
I now run all my homing and slave homing switches on 2 inputs on the breakout board, so I now have 2 connections free 1 being for the tool depth micro
Best regards Humbuk