My motor is only rated at 3.5kW so I would expect it to be close enough...
Those DSD drives are for servos right? Or could I potentially use one with my existing motor? I did notice that Fanuc literature is hard to find so just replacing what I have sounds more and more appealing, since I will no doubt have to set parameters and fix issues down the road.
I will look on eBay some more for a whole new motor/drive unit that is comparable as well. When looking for a motor I obviously need to match RPM and output, but for the IP/A+ENC what additional featureds should I be looking for? It can be open loop, but needs a differential encoder for the ENC, 0-10v speed control, anything else I'm missing?