Hi All,
For what this worth is worth, as i have a similar but different system, made by Multimek, and that pendant looks
almost the same. My system had steppers, drives, power supply, an interface board etc. The drives needed to be flashed based on a program which would control the stepper movements and the buttons on the pendant would, based on programing, could do basic control finctions. As a system, it was meant to do something over and over, like controlling robots. At first i though, woo....woo, a nice four axis contoller. Long story short........
The tech people said, even though you could convert it for a different controlling program like MACH, the drives and communications just wouldn't cut it for CNC machining and would be limited.
They said i would not be satisfied even if i got all working.
Would be nice if you could find out more about the drives. You have a box, power supply ( which should be adequate for the drives / steppers) and connections. So the controller is basically there. Just need to trace out the wiring and find out what each is for / connected to, so you can do some wiring changes as others have said.
Once that is known, you can add the other things BOB, SS or whatever to refine that controller to make it do what
you want with MACH.
Like I said, for whatever this is reply is worth, LOL
RICH