I've tried looking for info on 0 Pulse Frequency in Mach, but could not find any posts. I apologize if this is a common question.
I've just install the latest lockdown Mach 3 R3.042.020. I had version 1.84 working great before, but wanted to stay up-to-date with revisions. My system is an Intel Celeron D 2.6 Ghz on a ASUS P5S800-VM motherboard with 700+ Mb ram running WinXP with service pack 3. I've updated all the drivers and bios.
I've got windows stripped down and had version 1.84 working great. Upon installing R3.042.020 I can run DriverTest after running SpecialDriver and Mach takes control and shows pulses per second. It runs the test and completes. As a side note, if I try to run DriverTest using OriginalDriver, it does not output a pulse per second. I've always used SpecialDriver to get Mach to run on this machine and both DriverTest and Mach used to run fine.
Now DriverTest runs fine like I've mentioned, but when I run Mach under "Diagnostics" Pulse Frequency is 0. If pulse frequency is 0 nothing works. Why is pulse frequency 0? What other settings, besides SpecialDriver, affect pulse frequency? Thanks. Roger