Hello Guest it is March 28, 2024, 10:00:08 PM

Author Topic: Licening problem  (Read 8749 times)

0 Members and 1 Guest are viewing this topic.

Re: Licening problem
« Reply #10 on: June 19, 2006, 09:08:57 AM »
You need to set up your ports and pins :( If you look you have all the Step and Direction pins set to 2 & 3... once you set them to what you have in Mach2 you should be up and running :)
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Licening problem
« Reply #11 on: June 19, 2006, 06:18:15 PM »
will this fix the wizard problem to . wizard said that I was unlicensed .
Re: Licening problem
« Reply #12 on: June 19, 2006, 09:53:11 PM »
Motors running now . Last time I rubout Mach3 must have loss setup . Only problem now is Wizard stated unlicensed .

Offline ART

*
  • *
  •  1,702 1,702
  • Tough as soggy paper.
    • View Profile
Re: Licening problem
« Reply #13 on: June 19, 2006, 10:04:43 PM »
Hi:

 Thats because the Conversational Wizardsa are a separate license available only from www.newfangledsolutions.com

Art
Re: Licening problem
« Reply #14 on: June 20, 2006, 10:50:59 PM »
I wouldlike to thank youfor helping me through my  problems  an I will be gitting the wizard but don't like using paypal . Is there a nother way. ;D
Re: Licening problem
« Reply #15 on: June 20, 2006, 10:56:09 PM »
If you would like I can send you my address off line and  you could send a check..
Hope that works for you
Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com