Licening problem

Pages: « 1 2 Go Down

0 Members and 1 Guest are viewing this topic.

« Reply #10 on: June 19, 2006, 09:08:57 AM »

You need to set up your ports and pins

If you look you have all the Step and Direction pins set to 2 & 3... once you set them to what you have in Mach2 you should be up and running

Logged

Fixing problems one post at a time

« Reply #11 on: June 19, 2006, 06:18:15 PM »

will this fix the wizard problem to . wizard said that I was unlicensed .

Logged

« Reply #12 on: June 19, 2006, 09:53:11 PM »

Motors running now . Last time I rubout Mach3 must have loss setup . Only problem now is Wizard stated unlicensed .

Logged

« Reply #13 on: June 19, 2006, 10:04:43 PM »

Hi:

Thats because the Conversational Wizardsa are a separate license available only from www.newfangledsolutions.com

Art

Logged

« Reply #14 on: June 20, 2006, 10:50:59 PM »

I wouldlike to thank youfor helping me through my problems an I will be gitting the wizard but don't like using paypal . Is there a nother way.

Logged

« Reply #15 on: June 20, 2006, 10:56:09 PM »

If you would like I can send you my address off line and you could send a check..
Hope that works for you
Brian

Logged

Fixing problems one post at a time

Pages: « 1 2 Go Up