0 Members and 1 Guest are viewing this topic.
I built a router with two direct drive stepper motors for the x axis. The machine is 10 feet long and 5 feet wide. I'm using Mach3 and a 4 axis driver from Mecntronis (easy cnc). I've set mach3 to use A axis as the slave axis of the x axis. The motors are using a timming belt systam and the dirive is direct so one revloution is 1.5 inches in the x direction. I've set it up and it cuts circles pokets and all that stuff pretty accurate but rough my y axis is an acme thread and runs about 4 reves per inch and seems smooth. The x axis is jumpy at low speed, you can hear it move it sounds like about a 30 40 herts pulse. How you did connect the motors (wires wise) parallel o serial?Is there any thing I can do to smooth this x axis out. on curves you can see each step the motor makes?my thought is to make a couple of transmissions for the two motors so that each turns about 4 rev per in or so?any thoughts would be appriciated.Forrest