Hello Guest it is March 28, 2024, 03:35:28 PM

Author Topic: starting on a probe setter  (Read 3216 times)

0 Members and 1 Guest are viewing this topic.

Offline josh

*
  •  101 101
    • View Profile
starting on a probe setter
« on: July 20, 2008, 10:26:34 PM »
ok i am starting on a new project if anyone or everyone can help me get through this i would really appreciated.
here it is I now its been mention before I just wounder if you can guide me throught on step by step if its not to much
of a hassle.
I have seen were you can just load the tool then push the auto tool on the DRO and it will set that tool.
I dont know nothing on macro so it might be a challenge. anyways can you tell how to wire and make connection
I plan on using a piece of alluminum to touch off other than that I really dont know anything else.
so any help would be very appreciated
thanks

Offline poppabear

*
  • *
  •  2,235 2,235
  • Briceville, TN, USA
    • View Profile
Re: starting on a probe setter
« Reply #1 on: July 20, 2008, 10:50:25 PM »
do a search for a Tool change macro for a router, there was on on here a while back for touching off on an aluminum plate, I think............
fun times
Re: starting on a probe setter
« Reply #2 on: November 01, 2008, 05:19:06 PM »