Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: josh on July 20, 2008, 10:26:34 PM

Title: starting on a probe setter
Post by: josh on July 20, 2008, 10:26:34 PM
ok i am starting on a new project if anyone or everyone can help me get through this i would really appreciated.
here it is I now its been mention before I just wounder if you can guide me throught on step by step if its not to much
of a hassle.
I have seen were you can just load the tool then push the auto tool on the DRO and it will set that tool.
I dont know nothing on macro so it might be a challenge. anyways can you tell how to wire and make connection
I plan on using a piece of alluminum to touch off other than that I really dont know anything else.
so any help would be very appreciated
thanks
Title: Re: starting on a probe setter
Post by: poppabear on July 20, 2008, 10:50:25 PM
do a search for a Tool change macro for a router, there was on on here a while back for touching off on an aluminum plate, I think............
Title: Re: starting on a probe setter
Post by: softselect on November 01, 2008, 05:19:06 PM
ITS HERE http://www.cnczone.com/forums/showthread.php?p=436238