Hello Guest it is July 19, 2019, 12:21:51 AM

Author Topic: Ignore Tool Change  (Read 7157 times)

0 Members and 1 Guest are viewing this topic.

Re: Ignore Tool Change
« Reply #10 on: December 09, 2005, 02:09:39 PM »
All the settings are in the XML file and the tool table is in the Mach3\macros\Mach3Mill\tools3 file

when I do this I like to save all the macro's too :)


Hope that helps
Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Ignore Tool Change
« Reply #11 on: December 09, 2005, 05:12:51 PM »
Just a followup to the above problem.
I have discovered that if I enable or disable the 'ignore tool change box' using the settings tab, does not save the last known setting on exit. If however I use the boxes in the config/logic setups everything works as expected. Somthing is wrong with that checkbox when using the '(alt6)settings' tab.

Steve
Re: Ignore Tool Change
« Reply #12 on: December 09, 2005, 05:15:12 PM »
I didn't even think of the one on the settings page!

Thank you Very good to know!
Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com