here is a quick video i did to show you what i have done.
not there is some high pitch vibrating noise on one axis, this is just from loosening the motor to see if it was binding and its a few washers clattering together!
also not this was just done on another re-install, and i have also re botted mach3 everytime i have changed something too.
i have tried to explane the very best i can but i still think im not winning atall. i have looked on the internet high and low for the information pdf of the stepper boards i have etc... but cant find nothing!
im assuming my port and pin numbers are ok as they have worked fine in the past. as u can see i have just finished my machine and reconnected the motors and now i have stipped it down to the bear bones and taken off a motor to show you close up i hope!
i hope this helps
thanks again please dont give up on me, its taken me 6 months to get this far