I have my GREX/Mach IV system up and running.  Great stuff!    It appears that the start and end points of a line are wrong when using part offset and/or scaling.  Has anyone else seen this?

That may not be turned on the the software... I will forward that off to Art.

Hi :

 I havent tested scaleing, but part offsets should work.. Ill check it out though..

 Do ytou mean like G55 G56 , or just zeroing ??

Art

I was referinng to G41 and G42.  Due to my failure to read the tutorial, I was not aware that tool offsets are such a problem.  I was using the Mach 3 HPGL import.  I have since learned how to make Lazycam work.  It is actually quite easy once you find the layer control button.  The leadins make it all work much better.  I will post my remaing concerns in the general section. Thanks