Machsupport Forum
Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: sdspurlock on May 02, 2006, 07:24:59 PM
-
I have my GREX/Mach IV system up and running. Great stuff! It appears that the start and end points of a line are wrong when using part offset and/or scaling. Has anyone else seen this?
-
That may not be turned on the the software... I will forward that off to Art.
-
Hi :
I havent tested scaleing, but part offsets should work.. Ill check it out though..
Do ytou mean like G55 G56 , or just zeroing ??
Art
-
I was referinng to G41 and G42. Due to my failure to read the tutorial, I was not aware that tool offsets are such a problem. I was using the Mach 3 HPGL import. I have since learned how to make Lazycam work. It is actually quite easy once you find the layer control button. The leadins make it all work much better. I will post my remaing concerns in the general section. Thanks