Hello Guest it is May 09, 2021, 12:09:18 AM

Author Topic: Actual cutting path is not cutting over gcode path  (Read 2153 times)

0 Members and 1 Guest are viewing this topic.

Actual cutting path is not cutting over gcode path
« on: February 11, 2008, 04:43:12 PM »
I have a problem the Code path and the actual cutting path are off by 12 or more inches this is for a water jet and always uses relative coordinates.

Wayne

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: Actual cutting path is not cutting over gcode path
« Reply #1 on: February 11, 2008, 05:21:22 PM »
Hi, Wayne

Sounds like you have a work offset issue, Look on the Offsets page, Click the Machine Coord's Button, Do the DRO's change values ?

If thy do, change to your Program Run Screen, Ref-All-Home then click the Machine Cood's for "no red outline state", then Zero XYZ.

This is easy to get into if you say yes to Fixture Offset Save Yes/No after shutting down Mach.

Hope this is It, Chip

Tried to Skype you no one home.