Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: rwlove-lv on February 11, 2008, 04:43:12 PM

Title: Actual cutting path is not cutting over gcode path
Post by: rwlove-lv on February 11, 2008, 04:43:12 PM

I have a problem the Code path and the actual cutting path are off by 12 or more inches this is for a water jet and always uses relative coordinates.

Wayne

Title: Re: Actual cutting path is not cutting over gcode path
Post by: Chip on February 11, 2008, 05:21:22 PM

Hi, Wayne

Sounds like you have a work offset issue, Look on the Offsets page, Click the Machine Coord's Button, Do the DRO's change values ?

If thy do, change to your Program Run Screen, Ref-All-Home then click the Machine Cood's for "no red outline state", then Zero XYZ.

This is easy to get into if you say yes to Fixture Offset Save Yes/No after shutting down Mach.

Hope this is It, Chip

Tried to Skype you no one home.