Hello Guest it is May 05, 2025, 02:04:43 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: 24000 RPM to = 10 vdc from the Campbell combo board  (Read 8780 times)

0 Members and 1 Guest are viewing this topic.

Offline foprototype

*
  • 3 3
24000 RPM to = 10 vdc from the Campbell combo board
« on: February 03, 2008, 11:36:03 PM »
Hey Guys.
I need 24000 RPM to = 10 vdc from the Campbell combo board. At this point 13000rpm = 10 vdc.  What do I change? Is this done on the new spindle config page?
Thanks. Russ.
Logged

Offline TonyP

*
  • 132 132
Re: 24000 RPM to = 10 vdc from the Campbell combo board
« Reply #1 on: February 05, 2008, 02:41:37 PM »
Russ,
check your pulley settings. Assuming you have pulley 1 set, set the max speed as 24000 or a bit higher, ratio 1. That will probably get you into the right sort of area.

Tony
Logged
Pages: 1   Go Up
« previous next »