Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: foprototype on February 03, 2008, 11:36:03 PM
-
Hey Guys.
I need 24000 RPM to = 10 vdc from the Campbell combo board. At this point 13000rpm = 10 vdc. What do I change? Is this done on the new spindle config page?
Thanks. Russ.
-
Russ,
check your pulley settings. Assuming you have pulley 1 set, set the max speed as 24000 or a bit higher, ratio 1. That will probably get you into the right sort of area.
Tony