Hello Guest it is March 28, 2024, 07:27:21 PM

Author Topic: setting kernal speeds on Mach 3  (Read 3643 times)

0 Members and 1 Guest are viewing this topic.

setting kernal speeds on Mach 3
« on: December 12, 2007, 05:49:30 PM »
Hello all,

Can someone tell me where to get the kernal speed in mach3 ??    When the system was installed the kernal speed was set to 25k but I would like to change that value.

Also in the motor tuning field I can only set my velocity as high as  412. in /min.   mach will not let me go any faster??  Is there a way to overcome this ??


thanks in advance for any info !!

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: setting kernal speeds on Mach 3
« Reply #1 on: December 12, 2007, 06:17:41 PM »
Setting the kernel speed higher will allow faster velocity, that is if your motors/drives can handle it. You will find the kernel speed from the Config menu then the Ports and Pins page, right under where you set your port address.
Hood
« Last Edit: December 12, 2007, 06:19:43 PM by Hood »
Re: setting kernal speeds on Mach 3
« Reply #2 on: December 12, 2007, 06:28:23 PM »
Hood,

thanks for the info.  that was a great help !!!

Offline Bear

*
  •  15 15
    • View Profile
Re: setting kernal speeds on Mach 3
« Reply #3 on: December 15, 2007, 06:34:12 AM »
Merry Christmas,
Could help me with kernal speed as Im not much up with computers.
  Bear,
 thanks

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: setting kernal speeds on Mach 3
« Reply #4 on: December 15, 2007, 06:47:42 AM »
What are you needing help with?

Hood