Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: richyrich212 on December 12, 2007, 05:49:30 PM
-
Hello all,
Can someone tell me where to get the kernal speed in mach3 ?? When the system was installed the kernal speed was set to 25k but I would like to change that value.
Also in the motor tuning field I can only set my velocity as high as 412. in /min. mach will not let me go any faster?? Is there a way to overcome this ??
thanks in advance for any info !!
-
Setting the kernel speed higher will allow faster velocity, that is if your motors/drives can handle it. You will find the kernel speed from the Config menu then the Ports and Pins page, right under where you set your port address.
Hood
-
Hood,
thanks for the info. that was a great help !!!
-
Merry Christmas,
Could help me with kernal speed as Im not much up with computers.
Bear,
thanks
-
What are you needing help with?
Hood