Hello Guest it is October 20, 2019, 06:02:37 PM

Author Topic: David Murray  (Read 2287 times)

0 Members and 1 Guest are viewing this topic.

David Murray
« on: December 07, 2007, 05:14:32 AM »
Hi David
I see you have retro fitted a Starturn lathe, did you use a VFD to drive your spindle?

I am trying to retro fit an Orac, but having problems getting the spindle to turn via a VFD,

Can you offer any advice?

Thanks
Mike

Offline KTM

*
  •  92 92
    • View Profile
Re: David Murray
« Reply #1 on: December 11, 2007, 03:27:25 PM »
What kind of problems?
to start with go to Config - Ports and pins - Spindle setup

KTM
Re: David Murray
« Reply #2 on: December 12, 2007, 12:11:06 PM »
Hi David
Thanks for reply, I had an old VFD that came with the machine, so gave up on it and found a new one on ebay.

After playing with a few settings  got Mach to contol spindle, at last

What sort of stuff do you make on you machine?

Regards

Mike