Hello Guest it is March 29, 2024, 04:54:52 AM

Author Topic: Problem with MACH3 Mill  (Read 2547 times)

0 Members and 1 Guest are viewing this topic.

Problem with MACH3 Mill
« on: November 16, 2007, 01:47:08 AM »
Hi

I am using MACH3 for hobby cnc stepper motor application.

Since last time i find problem with MACH mill like i can run motor in only forward direction when use reverse direction key then only DRO is updating but motor is not moving.

Could you please advice,

Regards
Manoj

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: Problem with MACH3 Mill
« Reply #1 on: November 16, 2007, 03:09:37 AM »
Hi, Manoj

In config, ports & pins, motor outputs, change the "Direction Active Low" to opposite State.

If your motors run backwards, Config, Home & limits, Change the "Reversed", State.

Hope this Helps, Chip