Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: manoj2s on November 16, 2007, 01:47:08 AM
-
Hi
I am using MACH3 for hobby cnc stepper motor application.
Since last time i find problem with MACH mill like i can run motor in only forward direction when use reverse direction key then only DRO is updating but motor is not moving.
Could you please advice,
Regards
Manoj
-
Hi, Manoj
In config, ports & pins, motor outputs, change the "Direction Active Low" to opposite State.
If your motors run backwards, Config, Home & limits, Change the "Reversed", State.
Hope this Helps, Chip