0 Members and 1 Guest are viewing this topic.
okay so, I was checking the voltage at the DIR- and DIR+ Pin and got around 1.8 to 2.2v when I press the keypad in one direction and 0.0v when I hit the other direction. But Im assuming that's correct because it's set to half current on the jumpers which is 2.5v. but Im not getting any readings when I press the key towards the opposite direction on all three drivers. But, Z axis is till working in both directions. But, X and Y only work in one directions.
on Dir- Dir+ at the driver yous should allways measure 4,5-5V in one direction and 0V in the other.does not matter what you set for current.can you pls. post your profile XML and maybe some good pictures from your wiring and jumper settingsat the C10.
A photo of the set up may help, what drives and breakout board are you using etc.
When you power the board on you get a power led and a status led on? If status is off put 5V to EN connection.You have board set for pins 2 - 9 as OUTPUTYou have the board set for common GND so then pins 2 and 3 go to stepper driver PUL+ and DIR+ and PUL- and DIR- go to COM on the board.