Hello Guest it is May 03, 2025, 08:58:23 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Y moving in opposite direction  (Read 19657 times)

0 Members and 1 Guest are viewing this topic.

Offline anthony.zulli

*
  • 25 25
Y moving in opposite direction
« on: September 17, 2022, 03:39:33 AM »
Hi Group, my Y is moving towards me rather than away - I must have touched something I think?  Any help to get it back to normal please !
Logged

Offline Charlie_M

*
  • 181 181
Re: Y moving in opposite direction
« Reply #1 on: September 17, 2022, 06:18:52 AM »
 go to config/ports and under motor outputs  either check or uncheck the dir box for the y axis.
Logged
Regards
Charlie M.

Offline anthony.zulli

*
  • 25 25
Re: Y moving in opposite direction
« Reply #2 on: September 17, 2022, 07:27:54 AM »
Thankyou.  I noticed it continues to move to negative rather than to the positive, when going from negative Y to positive Y........any help????Please!!
Logged

Offline Charlie_M

*
  • 181 181
Re: Y moving in opposite direction
« Reply #3 on: September 17, 2022, 07:32:38 AM »
is this when you are jogging the machine? if so go to config/hotkeys and set Y  + and - keys.
Logged
Regards
Charlie M.

Offline anthony.zulli

*
  • 25 25
Re: Y moving in opposite direction
« Reply #4 on: September 17, 2022, 08:01:53 AM »
Thankyou. Its when it is reading the code running a program....the code says Y15 , but it moves from Y -10 to more negative Y, rather than moving to positive.....
Logged

Offline Charlie_M

*
  • 181 181
Re: Y moving in opposite direction
« Reply #5 on: September 17, 2022, 09:15:14 AM »
Then you have to set the y dir either active high or active low.
Logged
Regards
Charlie M.
Pages: 1   Go Up
« previous next »