Hello Guest it is March 28, 2024, 06:15:06 PM

Author Topic: ......Unable to change active plane of movement, strange behaviour......  (Read 2841 times)

0 Members and 1 Guest are viewing this topic.

Offline Tarak

*
  •  229 229
    • View Profile
I'm making a lathe screen and some of the program don't wok correctly unless I set active plane of movement to X-Z (in general config)
But when I restart Mach it resets it to X-Y?
Is this a glitch or is there something else I need to do.
I also haven't been able to set a toolpath display as a Turning control in screen 4, it always reverts back to normal, is this related somehow?

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: ......Unable to change active plane of movement, strange behaviour......
« Reply #1 on: October 18, 2007, 12:29:45 AM »
Hi, Darc

Did you start with a .Lset screen set, If not you'll need to rename it from .set to .Lset.

I use a program called XnVIew to rename them.

Hope this Helps, Chip

Offline Tarak

*
  •  229 229
    • View Profile
Re: ......Unable to change active plane of movement, strange behaviour......
« Reply #2 on: October 19, 2007, 02:26:53 AM »
Thanks Chip, I'll give that a go.