Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Tarak on October 17, 2007, 06:08:48 PM
-
I'm making a lathe screen and some of the program don't wok correctly unless I set active plane of movement to X-Z (in general config)
But when I restart Mach it resets it to X-Y?
Is this a glitch or is there something else I need to do.
I also haven't been able to set a toolpath display as a Turning control in screen 4, it always reverts back to normal, is this related somehow?
-
Hi, Darc
Did you start with a .Lset screen set, If not you'll need to rename it from .set to .Lset.
I use a program called XnVIew to rename them.
Hope this Helps, Chip
-
Thanks Chip, I'll give that a go.