Hello Guest it is April 18, 2024, 11:05:21 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Z axis not jogging or responding, x and Y are fine  (Read 698 times)

0 Members and 1 Guest are viewing this topic.

Offline Dgillard

*
  • 1 1
    • View Profile
Z axis not jogging or responding, x and Y are fine
« on: May 17, 2021, 05:20:28 PM »
Hi there, on a new install (last computer worked fine), the Z axis (up/down) will not respond at all. The numbers sometimes move, but the actual CNC does not. The X and Y axis are fine, respond to jog.
Logged

Offline Tweakie.CNC

*
  • *
  • 9,198 9,198
  • Super Kitty
    • View Profile
Re: Z axis not jogging or responding, x and Y are fine
« Reply #1 on: May 18, 2021, 01:51:47 AM »
Check that you have the correct Port and Pin numbers (Step and Direction) for your Z axis in Config. / Ports & Pins / Motor Outputs and also check that it is enabled.

Tweakie.
Logged
PEACE
Pages: 1   Go Up
« previous next »