Hood
the machine is a 1988 lagunmatic with a dynapath control right now i would be happy to just jog the tables so i can inspect and clean everything up the machine has just sat in a shop for about 2 years with out running there were no manuals for it, i tried to call dynapath for some info but as i said they were not to helpfull and stated it would cost about $2,500.00 just to replace one board or repair it i find that a lot of money for a few micro chip's.
i can look at the drives to see if there is any info on them if it helps thanks for the info on the skyco i will take a look this is why i asked if how to move the servo motor's can i take the 5V or ground to step and direction to get the motor's to run.
Dennis