low or high active depends on how your Inputs are connected.

for are quick try you can assign port/pin pin to spare Input and check on diagnostic page
via led's for right Level.

So i have try it... and it give the msg on all of them, and when i push there come light in, but if i push oemtrig 1 the machine start, and it i after push oem3 to stop it nothing happen, but it i reset again and push oem3 them i light and stop activate, but i can only push one oem, and then it do not react

My idea

Make a file pr oem and in the Main file write a triggermacro Line with all the file names

Oemtriggermacro 334
Oemtriggermacro 335
Oemtriggermacro 336
 

As example ?

Or do you have an idea why its only read one oemtrig ?

in the sample code oemtrig2 is for stopping not oemtrig3

you can Setup only one triggerfile

pls post your m333.m1s and m334.m1s and a screenshot of your System hotkey Setup Screen.

i have call it 1919 and 1920 i should not make any difference

little more

have you tryed to disable achtive Low?

real i think... not from keyboard

from the box

have you tryed to disable achtive Low?

this files are running, i have tested them.