Hello Guest it is May 11, 2025, 06:23:19 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: mach3mill error  (Read 7847 times)

0 Members and 2 Guests are viewing this topic.

Offline krymis

*
  • 52 52
mach3mill error
« on: October 04, 2007, 03:22:52 PM »
i started creating a g code from a bobcadv21 file i had.  I loaded it in mach3 v2.48.  when i load and start the program i get an error in the status line that reads "R less than Z in cycle in xy plane".  Any idea why?  Attached is a segment of the code.
Logged

Offline Graham Waterworth

*
  • *
  • 2,782 2,782
  • Yorkshire Dales, England
Re: mach3mill error
« Reply #1 on: October 05, 2007, 02:20:24 AM »
Hi,

on line N8 your R and Z are the same, I think your Z should be Z-.1

Graham.


Logged
Without engineers the world stops
Pages: 1   Go Up
« previous next »