Hello Guest it is December 06, 2021, 05:58:19 PM

Author Topic: mach3mill error  (Read 3397 times)

0 Members and 1 Guest are viewing this topic.

mach3mill error
« on: October 04, 2007, 03:22:52 PM »
i started creating a g code from a bobcadv21 file i had.  I loaded it in mach3 v2.48.  when i load and start the program i get an error in the status line that reads "R less than Z in cycle in xy plane".  Any idea why?  Attached is a segment of the code.

Online Graham Waterworth

*
  • *
  •  2,423 2,423
  • Yorkshire Dales, England
    • View Profile
Re: mach3mill error
« Reply #1 on: October 05, 2007, 02:20:24 AM »
Hi,

on line N8 your R and Z are the same, I think your Z should be Z-.1

Graham.


Without engineers the world stops