I think I did not explain myself properly.
When I home the machine, it will travel to the top right corner anything from there down and left are all positive numbers.
fNow, if I go to config> stops/soft spots and check reverse direction box I can reverse and come to the left bottom corner,however, at that time any time I move the gantry in any direction will change the numbers to an increasing negative.
I spend all day trying myself to and every time I try another change is not good.
If I move the X gantry to the right yea.. when moving left works but is on the wrong side. The Y is the one that the only way to change is to moved to the top of the table.
Please help perhaps I can post some photos if is not explained right