Hello Guest it is September 26, 2020, 06:29:20 PM

Author Topic: New user. My Z needs to raise higher between passes. M3  (Read 167 times)

0 Members and 1 Guest are viewing this topic.

New user. My Z needs to raise higher between passes. M3
« on: May 05, 2020, 08:59:30 PM »
Hello, and thanks for looking (and helping). I need my z to raise higher.Currently it raises about a 1/4" going from cut to cut (router) and I need it to raise, say, a half inch higher.  Also I have a ramping issue. When approaching start point from home, the router ramps down to position, I would like it not to, or have a shorter ramping distance.  In advance, thank you.
Re: New user. My Z needs to raise higher between passes. M3
« Reply #1 on: May 07, 2020, 04:26:29 PM »
You need to set safe-Z heights and ramping lengths in your CAD/CAM program.

Marsha