Hello Guest it is April 15, 2021, 08:03:14 AM

Author Topic: AXBB-E Controller  (Read 790 times)

0 Members and 1 Guest are viewing this topic.

AXBB-E Controller
« on: February 25, 2020, 05:49:39 AM »
I have purchased an AXBB-E ethernet controller to use with Mach3 and I cant get it to connect.
Has anyone used one of these and could they provide some assistance.
I have tried to setup as per the manual but no luck.

Offline Tweakie.CNC

*
  • *
  •  8,694 8,694
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: AXBB-E Controller
« Reply #1 on: February 25, 2020, 07:35:10 AM »
I doubt there are many here using the AXBB-E with Mach3 so asking the same question on the CNC Drive forum may produce results.  http://forum.cncdrive.com/viewforum.php?f=22
KEEP SAFE !