Hello Guest it is November 08, 2024, 10:17:03 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Spindle problem  (Read 2959 times)

0 Members and 1 Guest are viewing this topic.

Offline smtpl

*
  • 5 5
Spindle problem
« on: September 19, 2007, 02:24:03 AM »
When I start spindle through relay control it run for some time and then it stops if I do nothing on mach3 screen. When I start doing something on screen e.g. jogging then spindle starts again. Plaease help me to sole this problem.
Logged

vmax549

*
Re: Spindle problem
« Reply #1 on: September 19, 2007, 07:52:23 AM »
Sounds like your computer is going into sleep mode or power conserve mode. when you use the mouse it wakes up. Disable all power conservation modes. (;-) TP
Logged
Pages: 1   Go Up
« previous next »