Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: smtpl on September 19, 2007, 02:24:03 AM

Title: Spindle problem
Post by: smtpl on September 19, 2007, 02:24:03 AM

When I start spindle through relay control it run for some time and then it stops if I do nothing on mach3 screen. When I start doing something on screen e.g. jogging then spindle starts again. Plaease help me to sole this problem.

Title: Re: Spindle problem
Post by: vmax549 on September 19, 2007, 07:52:23 AM

Sounds like your computer is going into sleep mode or power conserve mode. when you use the mouse it wakes up. Disable all power conservation modes. (;-) TP