hello

so im moving my machine from mach 3 to mach 4 its is a cnc router with a galil dmc 4080 controller and uses a gantry with dual motors i have limit switches at each end of the axis and proximity switches for the homes but i want to know is there some way i can test the limits and the homes like the diagnostic page we use to have in mach 3 were you could see what limits, homes, and other inputs were active?

thanks for your help

Mach4 has a similar page, just look two tabs to the right of Program Run on the second line of tabs on the main screen. It is labeled "Machine Diagnostics"

Mach4 has a similar page, just look two tabs to the right of Program Run on the second line of tabs on the main screen. It is labeled "Machine Diagnostics"

thank you steve i turns out i had a different screen set on now i see the tab but again thank you very much time to setup these limits